Sewing machine noise |
Post Reply |
Author | |
mattthomas
Newbie Joined: 17-November-2005 Location: Watford Status: Offline Points: 18 |
Post Options
Thanks(0)
Posted: 12-September-2006 at 17:45 |
Hi all
My 318ti m44 has developed a sewing machine noise that is always present. Very quiet at low revs, much more obvious and ticky under load and high revs. I don't seem to be down on power as the car still pulls cleanly as ever. The only thing is that the idle is lumpy. It's due and oil change and I'll put some injector cleaner through it as well. Fuel has been run down to empty a few times lately so i'm worried the system has a partial blockage of old sediment. Is this likely to be a tappet thing? It's a 2000/X reg that has done 107k miles but has been serviced regularly. If it is a tappet problem does anyone have any idea what the cost of getting it fixed properly might be at a good independant specialist? |
|
Sponsored Links | |
editfmah
Groupie Joined: 29-June-2005 Location: United Kingdom Status: Offline Points: 64 |
Post Options
Thanks(0)
|
Believe it or not it's more likely to be a fracture in the Exhaust Manifold. Mine made that noise before it completely went!
|
|
E36 328i Touring + E36 Compact 318Ti
|
|
b318isp
Moderator Group Joined: 10-October-2002 Location: Ireland Status: Offline Points: 2057 |
Post Options
Thanks(0)
|
If the idle is lumpy, check for cracks/perishing everywhere around the inlet manifold.
If the exhaust manifold cracks, the noise with get worse under load. |
|
Old shape!
Really Senior Member I Joined: 08-January-2004 Location: United Kingdom Status: Offline Points: 497 |
Post Options
Thanks(0)
|
Sounds more like the fuel pump to me.
|
|
Paul DH
1994 E38 "Proud owner of a "3/4 engined E37.9 that's almost a real car with real paint...WITH 6 WASHER JETS!" 1989 520i (E34) Gone 1988 320i Coupe (E30) Gone 1995 520 Estate (E34) (Wife) 1992 320i SE OBC (E36) (Wife) Gone 1988 320i Saloon (E30) (Wife) Gone |
|
mattthomas
Newbie Joined: 17-November-2005 Location: Watford Status: Offline Points: 18 |
Post Options
Thanks(0)
|
Uh-oh. Hopefully it's just the manifold and I can get a guy to weld it up for me. Although if it needs replacing I could get a high flow job!
|
|
Post Reply | |
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |